Reiner 785 Instructions d'exploitation télécharger pdf (Page 37)

Reset

• With a Reset the device will be set to a defined status.

Furthermore the program run will be restarted (warm-start)

• The pin used to operate the Reset should have a diameter

of about 2,5 mm and a rounded end

• If a thinner pin with a sharp end is used (particularly a metal

pin, e.g. a straightened paper clip), there is a danger of

damage to the switch and PCB if it is not used very carefully

Carry out a Reset

Remove the front cover (7)

Press a thin pin-shaped object, about 4 cm long, vertically

into the small circular opening (see arrow) on the left below

the display (using for example a bent open paper clip)

until the display shows Test

Close the front cover (7)

The program is restarted. If the program is now being executed

correctly, time, date and data of numberer will be reset and

can now be set again

Note

1 2 ... 32 33 34 35 36 37 38 39 40

Pas de commentaire

Reiner 785 Instructions d'exploitation Page 37